· Share - Magnetek GPD Motor Drive Technical Manual. Magnetek GPD Motor Drive Technical Manual. out of 5 stars 1 product rating. average based on 1 product rating. 5. 0 users rated this 5 out of 5 stars 0. 4. 0 users rated this 4 out of 5 stars 0. 3. 0 users rated this 3 out of 5 stars 0. www.doorway.ru: Magnetek. GPD DS, 5 HP Keypad NOT www.doorway.ru Rating: % positive. The GPD leaves the factory with all constants set for 2-Wire external ref-erence control. Figure 1–5 must be used for all external con-nections. To use the GPD in a 3-Wire application, drive constants noand nomust be reprogrammed, using the optional Digital Operator, Model DS Figure must then be used for all external connections.
gpd control pcb 4 6 b1 b2 part of external circuit braking resistor unit (10% duty cycle) b p 2 1 thg thrx 1m 1m 1m cb l1 l2 l3 vac thrx fault contact thrx rc 1m 1m rc thrx power on power off * * customer supplied components figure 5. wiring braking resistor unit (10% duty cycle) to drive. The GPD leaves the factory with all constants set for 2-Wire external ref-erence control. Figure 1–5 must be used for all external con-nections. To use the GPD in a 3-Wire application, drive constants noand nomust be reprogrammed, using the optional Digital Operator, Model DS Figure must then be used for all external connections. DS Operation of the GPD by means of the Digital Operator, Model DS, is identical to operation by means of Digital Operator, Model No. DS, as described in the GPD technical manual, except that the key marked JOG on the DS will control the LOCAL – REMOTE function of the GPD (See installation step 9.) IMPORTANT.
On Hand, Manufacture, Series, Model, Horsepower, Volts, Amps, Phase, Notes. 1, MagneTek, GPD , DS, ¾, , 3, 3, Technical Manual Included. System Design Suggestions for Troubleshooting Success. (GPD). (L/h). (bar). (psi). NF , 4, 8. – 14, – 2, In this manual, and in other documents, we use two terms: Flow Meter = Assembly including a display (register). Flow Sensor = Assembly without display. (might.
0コメント